2024 Teagle Tomahawk 505XLM

2024 Teagle Tomahawk 505XLM

The farmers choice for producing consistently short material from dry bales.

Fast effective milling of straw and miscanthus to a very consistent chop length, as short as 13 / 8".

Blow straw up to 30', discharge to one or both sides of the tractor. Alternative delivery chutes are available to suit your requirements.

The Tomahawk 404M, 505M and 505XLM bale processors use blades or hammers to chop dry material small enough to pass through the holes in a screen. A range of screens are available with holes from 3/8 " to 13/8" to obtain material of a consistent chop length.

Easy control of output by adjusting the speed of drum rotation.

• Tomahawk 505XLM - Suitable for 5' diameter bales and full size Hesston bales.

The 404M/505M/505XLM range is suitable for dry material only, and will not cut silage as it will block the mill sieve.

Features may include:

Easy Loading

Netting or wrap is easily removed at a safe working height.

Knife system for high feed rate - use only with screen sizes greater than 12mm.

Hammer system for heavier duty or stoney applications and very short chop lengths.

Length of material is determined by the screen which is fitted. The nature of the material has some effect upon actual shredded length and some variation is likely to occur. Screen sizes available are 10, 12, 15, 18, 21, 28, 36, 50mm holes and 120mm slots.

Front

Chute on the left and right hand sides can be opened and closed independently.

Direct drive from rotor to shaft - no gearbox.

For driveline protection a slip clutch is fitted as standard on the PTO shaft.